cisco AIR-AP3702I-UXK9 flashing red/green/off but is registered to WLC
As in title, I have 4 x cisco AIR-AP3702I-UXK9 flashing red/green/off eve though they are all registered to a WLC and have clients connected.
There is nothing in the logs to suggest an issue. We did have problems registering these APs to begin with, the WLC was saying that the regulatory domain of the AP didnot match the WLC but I was able to get them to register after upgrading the WLC to SW 18.104.22.168. and the current universal prime status is: unprimed.
Go the the AP in question and go into the "Advanced" tab. Look at "Regulatory Domains". Maybe it's because the AP is still in "-UX" mode. Read the User Guide link above to set the correct Regulatory Domains to one of the AP and the rest will "follow".
Hello Community, I have an issue where APs do not connect to the WLC. Connection is made over VPN. Until yesterday all 3 APfailed with below errors. We change the LAN connection to a cisco router and now one of the AP magically connected to the...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...
Cisco Champion Radio · S8|E6: Fastlane+ Optimizes Network and Device Communication
Cisco Fastlane+ is a co-developed solution with Apple that significantly improves the experience of any Wi-Fi 6 capable iPhone or iPad connected to a Cisco Catalyst 9130 A...
We are pleased to announce the immediate availability of the IOS-XE release 17.4.1 for the Catalyst Wireless Controllers. The new code is now posted on the CCO and can be found at this link:
Table of Contents
The purpose of this document is to provide step-by-step instructions regarding how to connect your read-only Catalyst 9800 WLC or AireOS WLC with Cisco DNA Center for Assurance monitoring through manual configuration. I...