Cisco Aironet 1400 - security

[holzhirt1]

Dear all,

I'm currently configuring 2 Cisco 1400 Bridges. One is the root bridge the other the non-root bridge (ok logic ).

I wanted to know what is possible for using certificates for the non-root bridge or to use the local radius on the root bridge to increase the security level of the wlan network.

I tried to reach the local radius on the root bridge, but I'm always getting a 404 error. After reading some Cisco docs, it said that we need to use AAA new model from the CLI, I did it without success.

What would you recommend to ensure a good security level for the wireless link?

I'm open to use certificates or a Radius (local or IAS) or any suggestions you may have.

Any help or or suggestions are very welcomed...

Thanks per advance,

Regards

[dixho · Accepted solution]

The only EAP types supported by BR1410 is LEAP. You should able to configure LEAP client on the non-root bridge:

http://www.cisco.com/en/US/docs/wireless/access_point/12.2_15_JA/configuration/guide/s15rep.html#wp1036921

The above URL is for repeater; however, it is the same for non-root bridge.

You may already know. If you want to set up local radius server, the following URL should be useful:

http://www.cisco.com/en/US/docs/wireless/access_point/12.2_15_JA/configuration/guide/s15local.html

[holzhirt1]

Hello Dixho,

thank you very much for your feedback, appreciated.

It was useful for me,

Have a nice week ahead

[Vinay Sharma]

thanks Dixho for this useful information and helping the Cisco customers.

Regards,

Vinay

[dmantill]

Wow!Hello Dixon!

How are you doing?! Its nice to see you around CSC.

This is dmantill, from cr-wireless. How is everything going on TAC?