Cisco AP 2702 with static IP address, GW and WLC config

[HANS VASTERS]

Hello all,

I configured an Cisco AP 2702 on the CLI with the following CAPWAP Paramters:

capwap ap ip address 172.21.144.232 255.255.255.0

capwap ap ip default-gateway 172.21.144.254

capwap ap controller ip address 12.149.2.52

Normaly (with other models) it should now try to connect the WLC directly. But on the Console I can only see that the AP tries to resolve the name CISCO-CAPWAP-CONTROLLER. I am doing that because in the environment where I have to install the AP we do not have DHCP. I also cannot configrue the Name in our DNS. So as I explained this is normaly the way it worked so far with 1130, 1240, 1140, 1250, 2600. But now with the 2702 it does not work.

Any idea how I can get this working?

[Leo Laohoo]

The controller IP address is 12.149.2.52 and the AP IP address is a 17.21.144.0/24?  Must be a type-o? 

Can the AP ping the controller IP address?

[HANS VASTERS]

Yes, the IP settings are correct and of course I can ping from the AP to the WLC and vice versa.

[Leo Laohoo]

Ok, post the complete output for the following commands: 

1.  WLC:  sh sysinfo; 

2.  WLC:  sh time; 

3.  AP:  sh version