cisco C1117-4PWE as a controller wireless

[Dhikra Marghli]

Hello

I have :

cisco C1117-4PWE (1RU) processor with 1452736K/6147K bytes of memory.
Processor board ID FGL2429L79K
1 Ethernet interface
1 Virtual Ethernet interface
6 Gigabit Ethernet interfaces
1 ATM interface
4294966432 terminal lines
32768K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
2945023K bytes of flash memory at bootflash:.
0K bytes of WebUI ODM Files at webui:.

Configuration register is 0x2102

///////////////////////////////////////////////////////////////////////////////////

Router#show running-config interface wlan-GigabitEthernet 0/1/4
Building configuration...

Current configuration : 43 bytes
!
interface Wlan-GigabitEthernet0/1/4
end

////////////////////////////////////////////////////////////////////////////////////////////////

so how i can configure this router cisco C1117-4PWE  as a controller wirless cisco !!!  

i wait a reply from expert wirless help me  and answer me 

thanks in advance

[Sandeep Choudhary · Accepted solution]

Check this doc:

https://www.cisco.com/c/en/us/td/docs/routers/access/1100/software/configuration/xe-16-7/cisco_1100_series_swcfg_xe_16_7_x/cisco_1100_series_swcfg_chapter_01010.html#con_1059792

Also check this video:

https://www.youtube.com/watch?v=pxuS7haLpow&ab_channel=ShambhuNathMishra

Regards

Dont forget to rate helpful posts

[Dhikra Marghli]

Thanks Sandeep to help me 

[Nicola A]

How to config same model with internal ap as autonomous? thanks at all

i can config with simple wizard webui but that config not permit wan interface config, see cli preview and when i clic put on router.. the successfull commit is a fake cause the router dont have that config. thanks all. ios xe ver. 17.0.3