Cisco Prime Infrastructure 3.1 Reporting incorrect number of users on AP's
I seem to have several outdoor AP's (AIR-CAP1552E-A-K9) that report in Prime Infrastructure to have a lot of clients yet when I check on the AP's directly they is very few. It appears as though Prime is not releasing the data. In one case it shows 150 5gig clients yet the AP only has 2 currently attached... I have rebooted the AP and you see the stats in prime show an overall drop of 150 clients then it jumps right back up.
Is this a bug? I have been running the same code for a while and haven't seen this so I am wondering if it is just the database that is getting corrupt...
Table of Contents
Table of ContentsOverviewConnecting a Catalyst 9800 WLC to Cisco DNA Center ManuallyConnecting an AireOS WLC to Cisco DNA Center ManuallyCisco DNA Center Assurance Deployment Guide References
The purpose of this document...
Securing devices without 802.1X
PSK (Pre-Shared-Key) WLAN is widely used for consumer & enterprise IoT onboarding as most of IoT device doesn’t support 802.1X. While PSK WLAN provides an easy way to onboard IoT, it also introduces challenges as...
Due to the certificate expiration, any new Control and Provisioning of Wireless Access Points (CAPWAP) or Light Weight Access Point Protocol (LWAPP) connection will fail to establish. The main feature that is affected will be the Acce...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...