cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
233
Views
5
Helpful
3
Replies

Cisco WLC 5508- Mobility tunnel creation

networklearner1
Beginner
Beginner

Hello All,

In our current wireless setup, we already have an Anchor WLC (5508) which is mapped to the Foreign WLC (5508).

I need to add a new Anchor WLC to the Foreign WLC. 

The Foreign WLC's are in HA pair. My question is, since the Foreign WLC's are in active-standby setup, do I need to just add the new Anchor IP in the Active foreign WLC or do I need to disable SSO and add the IP in both WLC's separately.

Please suggest.

Thank you.

 

1 Accepted Solution

Accepted Solutions

ammahend
VIP
VIP

yes, just need to add the new Anchor IP in the Active foreign WLC, No need to disable SSO. 

-hope this helps-

View solution in original post

3 Replies 3

RoadRunner4k
Beginner
Beginner

You should only add one IP ( the shared AP Mgmt IP this will be shared among the two devices)  use the MAC Address ( controller -->Redundancy --> Global Configuration ( Mobility Mac address)

ammahend
VIP
VIP

yes, just need to add the new Anchor IP in the Active foreign WLC, No need to disable SSO. 

-hope this helps-

networklearner1
Beginner
Beginner

Thank you @RoadRunner4k @ammahend 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: