08-21-2014 04:56 AM - edited 07-05-2021 01:24 AM
Hello
i need your help
i want to configure Cisco WLC 5508 whith 03 vlans, 3750 as core swich
- management Vlan
- local-user vlan
- Guest Vlan
i want to know all steps or config to do on WLC
thx
08-21-2014 05:28 AM
Hi,
Just check this.
It may help u.
Wireless LAN Controller and Lightweight Access Point Basic Configuration Example
http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/69719-wlc-lwap-config.html
http://rscciew.wordpress.com/2014/01/22/configure-dynamic-interface-on-wlc/
Webauth for guest users:
http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/69340-web-auth-config.html
http://rscciew.wordpress.com/2014/06/19/wlc-webauth-configuration/
Regards
10-06-2014 04:03 AM
thank's for all answers
08-21-2014 10:38 AM
Hello,
For the port connecting switch and controller make sure its trunk & create the three VLANs you want to use
After the initial configurations you will have management VLAN (as its required to enter the managment IP)
Controller -> interfaces
create the two interfaces for local-user vlan and guest vlan
make sure to enter the correct vlan/ subnet/ gateway / DHCP
Now go to WLAN tab
create the SSIDs and link each to the interface
You can add different security settings for each WLAN.
Hope this was helpful!
Cheers,
Nour
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: