Cisco WLC new config

[frederick.mercado]

Hi! So I am fairly new to the WLC game. 

I have my 9800 LC controller setup and I can reach it on my VLAN setup for wireless, but would like to use the service port or OOB for management. Not the in bound. 

[Haydn Andrews]

Remember the service port is in the management VRF so you also need to update the routing for that subnet on the WLC.

interface GigabitEthernet0/0

 description SP_out_of_band

 vrf forwarding Mgmt-intf

 ip address 10.58.55.246 255.255.255.0

 negotiation auto

!

ip route vrf Mgmt-intf 10.58.0.0 255.255.0.0 10.58.55.254

[balaji.bandi]

follow below guide : (service port config)

https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/guide-c07-743627.html