CLI Commands needed for a SW Catalyst2960 port work for AP Aironet1830

[pdenableetoavit19698]

Hi there

I want to make an empty port on a cisco catalyst 2960+, available/ok for connecting an extra AP Aironet 1830 under ME.

Which command should I use to make the port TRUNK and any other config needed for that port?

Thank you

[marce1000]

 - Review this document https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/68100-wlan-controllers-vlans.html and or as a  example : https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/68100-wlan-controllers-vlans.html#anc10

 M.