11-23-2022 06:34 AM
Morning everybody,
I come to you because i had bought 2 AP C9105AX to manage my WIFI network on premise with the Controller Embedded on this AP. With all logistic problems we knew, i receive my AP after an important meeting in which all personns had to be connected in WIFI.
So, i contact a cisco technical commercial to buy in emergency an AP that i could join to my Controller Embedded on my C9105 AP. he said me to buy the CBW105AX AP.
I have today all my AP, i configure my 9105 embedded controller with my 2 AP. Everything is OK. But, when i try to join my CBW105, it doesn't work. I update all the AP, register the SN into the controller, the MAC address to finally obtain the message AP no compatibility.
Did i make a mistake on my configuration or is really not possible to join my controller with this CBW150?
Thanks for you help.
PS: Sorry for my english, i'm a poor french boy...
----------------------------------------
Bonjour à tous,
Je la refais en français, ça va être plus facile pour les francophones, dès fois que.
J'avais acheté 2 bornes 9105AX afin de gérer mon wifi via le contrôleur intégré (je suis monosite). Avec les problèmes d'appro, les bornes ont tardés à arriver, et j'ai dû équiper en urgence une salle de réunion ou tout le monde devait être en WIFI.
J'ai contacté un commercial Cisco pour connaitre les bornes WIFI 6 compatible avec ce contrôleur et disponible de suite chez mon revendeur. Il m'a orienté vers la borne CBW150AX en me disant qu'il n'y aurait pas de problème ensuite pour l'intégrer à mon réseau via le contrôleur.
Sauf que, je viens de recevoir tout mon matériel et j'ai paramétré mon contrôleur sur mon C9105 et cela fonctionne bien avec mes deux bornes. Mais que je veux joindre la CBW150AX, cela ne fonctionne pas.
J'ai mis toutes mes AP à jour, ajouté l'adresse mac, ainsi que le SN et le message est passé de Auth failure à Incomptability AP.
Est-ce que je m'arrache les cheveux pour rien ou me suis-je trompé dans la conf?
En vous remerciant pour votre aide
Solved! Go to Solution.
11-23-2022 06:59 AM
This table might help with what ap's are supported:
11-23-2022 06:43 AM
I think they were mistaken. EWC only supports certain access points. You are better off getting the same model ap or another 91xx access point.
Cisco Embedded Wireless Controller for an AP Data Sheet - Cisco
11-23-2022 06:59 AM
This table might help with what ap's are supported:
11-25-2022 06:29 AM
I'm afraid you're right...
The second link killed my hopes...
I gave up and i will change my plans.
Thanks for your answers
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: