I configured one vlan and trying to authenticate it through radius server.My objective is when a internal users want to connect through this SSID they just put username and password and authenticate through Radius server. Another vlan is getting authenticated through mac address that i need to manually put in AP.
Can any one please tell me where i ma making mistake.
You need to provide more informaiton about your problem: - are you using autonomous or unified AP? (for now I think it is autonomous). - what do you exactly mean by users to provide username/password pairs? where should they enter those info?
- is there any eap type you want ot use? (PEAP, EAP-FAST...etc)?
Beside the link provided by Srini about configuring multiple SSIDs, Here is a link which a bit show configuring 802.1x security on the SSID:
Table of Contents
Table of ContentsOverviewConnecting a Catalyst 9800 WLC to Cisco DNA Center ManuallyConnecting an AireOS WLC to Cisco DNA Center ManuallyCisco DNA Center Assurance Deployment Guide References
The purpose of this document...
Securing devices without 802.1X
PSK (Pre-Shared-Key) WLAN is widely used for consumer & enterprise IoT onboarding as most of IoT device doesn’t support 802.1X. While PSK WLAN provides an easy way to onboard IoT, it also introduces challenges as...
Due to the certificate expiration, any new Control and Provisioning of Wireless Access Points (CAPWAP) or Light Weight Access Point Protocol (LWAPP) connection will fail to establish. The main feature that is affected will be the Acce...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...