cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7979
Views
0
Helpful
4
Replies

Configuring Guest Access using 2 LWAPs and 2504 WLC

Please advise,

I have 2 APs, Cisco Aironet 1040, and 2504 WLC.

Is it possible to configure guest access (Guest SSID/VLAN and Corporative SSID/VLAN) without dedicated guest WLC in DMZ?

2 Accepted Solutions

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

Yes you can. You can have up to 16 SSIDs per AP, but not suggested to have all 16. You can either use one port on the 2504 for both SSID/vlan or specify which port is for corporate and which one is for guest.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***

View solution in original post

Scott Fella
Hall of Fame
Hall of Fame

Here is a good guide on the 2500

http://www.cisco.com/en/US/products/ps11630/products_tech_note09186a0080b8450c.shtml#scenarios

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***

View solution in original post

4 Replies 4

Scott Fella
Hall of Fame
Hall of Fame

Yes you can. You can have up to 16 SSIDs per AP, but not suggested to have all 16. You can either use one port on the 2504 for both SSID/vlan or specify which port is for corporate and which one is for guest.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***

Scott Fella
Hall of Fame
Hall of Fame

Here is a good guide on the 2500

http://www.cisco.com/en/US/products/ps11630/products_tech_note09186a0080b8450c.shtml#scenarios

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***

Thank you, Scott!

No problem

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
Review Cisco Networking for a $25 gift card