cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
264
Views
2
Helpful
3
Replies

Congestion issue on AP CISCO AIR-AP2702E-UXK9 with unused bandwidth

engenzirabona
Level 1
Level 1

Dear Cisco Engineers,

I have configured and installed 6 cisco AIR-AP2702E-UXK9 access points for a customer whose Intenet provider gives him 60Mbps.

-I have 5 different zones to cover,

-Among these 5 zones, there are two main areas that need to host an average of 200-300 users at the same time.

-In one of the two main areas, I've installed 2 cisco access points, to give users more chance to be connected at the same time, ( for example 250-400 users).

-In the 2nd main zone, I installed 1 single access point, to give at least 100-200 users the chance to be connected at the same time.

-In the 3rd zone, I've installed a single AP

-In the 4th zone, a single AP

-In the 5th zone, a single AP

Unfortunately, there's always the problem of congestion at peak times, when we can receive 200-400 users at the same time, in almost every zone.

But, when I look at the daily graph of network behavior, we've never reached the throughput threshold provided by the provider. We never reached 45Mbps, even though we have 60Mbps from the source.

-In our configurations, we used class A. The network connectivity is via optical fiber, the router is Cisco ISR 4331, and the switch is CISCO Catalyst 2960.

Could you give us some suggestions for solving this problem?

Thank you.

3 Replies 3

marce1000
VIP
VIP

 

 - FYI : https://community.cisco.com/t5/wireless/wireless-access-point-maximum-users/m-p/3042361#M50853

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !