cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
844
Views
0
Helpful
1
Replies

Default image mismatch between active and standby WLC

ondjultomte
Level 1
Level 1

(Cisco Controller) >show boot
Primary Boot Image............................... 8.3.133.0 (active)
Backup Boot Image................................ 8.2.151.0 (default)

 

(Cisco Controller-Standby) >show boot
Primary Boot Image............................... 8.3.133.0 (default) (active)
Backup Boot Image................................ 8.2.151.0

 

How can I set both WLCs to use 3.133 on reboot?

Do I need to upload the image again?

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame
Config boot primary. That will make the primary controller have the active/default image.
-Scott
*** Please rate helpful posts ***
Review Cisco Networking for a $25 gift card