05-05-2011 09:13 AM - edited 07-03-2021 08:09 PM
hi! I did a conversion from autonomous AP to lightweight AP (1240) using the cisco upgrade tool. After the conversion, i tried to console into the AP but the default password of Cisco and username Cisco doesn;t work. Any idea what's the default password after the conversion? I know that i can change that from the controller, but is that the only way to do it? Thanks.
05-05-2011 09:15 AM
default is Cisco/Cisco, you may want to try the user/pass that you had when it was autonomous.
Cheers,
Steve
--
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
05-05-2011 09:36 AM
Hi,
If the AP is already registered to the WLC, then the only way is to configure the same sing the WLC GUI... If its not yet registered, then password recovery using Mode button does not work on the LWAPP APs...
Lemme know if this answered ur question!!
Regards
Surendra
06-03-2011 08:18 AM
Dave,
Please mark this Question as "Answered" if you got the correct information from Stephen and surendra.
thanks,
Vinay
09-20-2019 11:07 AM
I've tried Cisco/Cisco and it doesn't work. I've also tried admin/cisco and that doesn't work. Any ideas?
09-23-2019 08:14 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide