cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
561
Views
5
Helpful
3
Replies

Deny Traffic between 2 AccessPoints

How can i deny a traffic by 2 AccessPoints by 2 Clients?

 

So they will make a direct connection by my infrastructure LAN by 2 AccessPoints.

 

Is there a command where i can block and only allow the traffic to the internet on a Cisco 1532 AccessPoint?

 

Maybe the same as Wifi Direct but with 2 Accesspoints.

 

thanks

 

 

3 Replies 3

Are these AP are managed by single WLC ? if so you can set "P2P blocking action" to "Drop" under SSID advanced configuration.

 

HTH

Rasika

*** Pls rate all useful responses ***

They are standalone AP so no WLC.

 

If someone logged in at one AP and an other user on the other Ap they can make a direct connection by my infrastructure. So how can i deny this?

 

best regards

 

If you want to block clients connection within same AP, you can implement P2P blocking on radio level (it is known as Public Secure Packet Forwarding - PSPF in autonomous deployment)

 

Under specific radio interface (or sub-interface depend on you have multiple SSID), you can issue below command (use appropriate bridge group number as per your config).

bridge-group x port-protected

 

Above does not block if clients connecting to two different APs. If both APs connect to same switch, you can implement below. 

https://learningnetwork.cisco.com/thread/31691

 

interface x/x

switchport protected

 

Give it a try and let us know how it goes

 

HTH

Rasika

*** Pls rate all useful responses ***

Review Cisco Networking for a $25 gift card