Detect rougue access points on the wire.

[DAVID]

I am looking for a walk-through or some sort of guidance on configuring an access point in monitor mode to detect a rouge AP that I place wired to the network to detect that rogue AP and to alert me to the existence of that rogue AP.

I have the 5520 WLC running 8.2.110

Access points are 37021 and I have a 3702i in monitor mode.

I am using a Cisco/Linksys e4200 as my test rogue AP

[Leo Laohoo]

The controller has SNMP traps to determine if the rogue AP is "on the wire".

[mohanak]

Refer link : https://supportforums.cisco.com/discussion/12496581/detect-wired-rogue-access-point-production-network

[DAVID]

Based upon this post I can't use the typical Linksys/Cisco SOHO type router/access point because of the NAT issue.  Would it make a difference if I have installed DD_WRT on the device or should I be using a Cisco AP