cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
141
Views
3
Helpful
2
Replies

Disable CDP on specific Access Point on Cisco C9800 (IOS-XE 17.9.x)

Dominic Stalder
Level 1
Level 1

Hi guys

maybe that's a pretty stupid question, but how can I disable CDP on a specific Cisco access point on a Cisco C9800 with IOS-XE 17.9.x:

1. There is a way to show the actual CDP state of each Cisco access point registered on the C9800:

cisco-wlc-9800-mgmt#show ap cdp

AP Name AP CDP State
------------------------------------------------------
xyz1 Enabled
xyz2 Enabled
...

2. But I can (yet) find a way to disable this feature; I looked into the AP join profiles and the specific ap configuration options

Any hint on this?

Thanks and best regards

Dominic

1 Accepted Solution

Accepted Solutions

marce1000
Hall of Fame
Hall of Fame

 

 - Ref : https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/new-configuration-model.html#config-ap-profile-gui
                Take a look at Step 9.

  M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

View solution in original post

2 Replies 2

marce1000
Hall of Fame
Hall of Fame

 

 - Ref : https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/new-configuration-model.html#config-ap-profile-gui
                Take a look at Step 9.

  M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Thanks, not sure why I did not see the sub tab for CDP interface.

Review Cisco Networking for a $25 gift card