08-14-2009 07:04 AM - edited 07-03-2021 05:56 PM
Hi All,
Is there anyone who can tell me if there is command that I can use within the IOS on an access point (1131) that will display what radio channel it is using?
At the moment I am having to use NetStumbler to identify what channels access points are using, it would be so much easier if there was a command along the lines of 'show interface dot11radio 0 channel'
Thanks
Ryan
Solved! Go to Solution.
08-14-2009 07:36 AM
08-14-2009 07:36 AM
Yes, it's easy:
show controllers dot11Radio 0
hope it helps
jerome
08-14-2009 07:42 AM
Thanks, that has done the trick.
I have spent ages trying to find out what the command was. I knew there had to be one somewhere.
Thanks again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: