cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
254
Views
0
Helpful
3
Replies
vesmenjaud
Beginner

Does IW6300 support CleanAir and RF jamming detection?

 
3 REPLIES 3
Scott Fella
Hall of Fame Master

All of the new Cisco Enterprise access points support clean air. The controller you use and code will determine what can be detected. Look at the data sheet for the access point and then also look at the configuration guide for the firmware you are running on the controller.
-Scott
*** Please rate helpful posts ***

Thank you Scott, actually I've been a bit confused. There is nothing mentionned about CleanAir or Cisco RF ASIC within the current PDS which is quite recent (March 4, 2020). In the other end, the information is in front and clearly mentionned within the PDS of the 9130.

Even if within the the release notes of the latest release supported by the IW6300 (rev 15.3.3-JPK(ED)), the feature “Clean Air” is mentioned, it is generic and not realy obvious for our customers. I was looking for a document which makes an evidence of this. My customer is still septic.

Vincent

Leo Laohoo
VIP Community Legend

By default, yes.  

Content for Community-Ad