Enable three antennas or just two , AIR-ANT2430V-R 2.4 gHZ.

[filiberto.aguirre]

Hi,

I have configured an antenna AIR-ANT2430V-R 2.4 gHZ for LAP 1262N-A-k9 using WLC-2106.

The devices that are going to associate are hand helds that just support standard b,g; so I would like
to know if It would have any advantage if I enable all the antennas (three) taking into account that the device just
support standard b,g but not n.

what about if I enable just antenna A(tx,rx), and C (rx).

regards

[Nicolas Darchis]

If you are to enable 2 antennas, enable A and B.

You get advantage of having all antennas if you active the clientlink (a.k.a beamforming) feature. This uses the 2 antennas transmitting simulatenously to give a signal boost to b/g clients.

Nicolas