Error in adding Data Points in WCS when using Intel 5100 AGN card
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-10-2010 11:59 PM - edited 07-03-2021 06:47 PM
I am using Wireless Control System (WCS) 6 and when I try to add data points in a custom calibration model I created, I get an error message "No data points collected when starting from location (X,Y)" only when using Intel 5100 AGN as the client. I know that in order to add Data Points, I need to have a wireless card that supports Cisco CCX, this Intel card supports CCX 4.
I have done added data points using my older computer that uses an older Intel card and it works fine. I used another computer that has a Dell Wireless 1510 Wireless-N card and it works too. The driver on the Intel 5100 AGN is 13.1.1.1(13/01/2010)
Is there a solution to this or is the Intel 5100 AGN just not supported?
- Labels:
-
Wireless Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-11-2010 01:54 AM
There is probably something with the card and the CCX support.
Have you tried to do a wireless packet capture to make sure it does indeed support CCX?
We dont test other vendor nic cards for the driver / feature reason, it makes it about impossible to track all the NIC cards, hence we recommend the card we have since we know that the driver is correct.
----
Please support CSC Helps Haiti
https://supportforums.cisco.com/docs/DOC-8895
