Error in configuration of APs

[Muhammad Noman]

Dear All,

I am trying to configure controller based AP but not AP is not able to appearing on controller. Upon power on of AP it appears on controller for a second or two and then disappears with following message errors.

Regards,

Muhammad Noman

[Sandeep Choudhary · Accepted solution]

Paste the output of these commands:

sh sysinfo from WLC

sh version from AP

*** I suspect that Regulatory mismatch is there...

Regards

Dont forget to rate helpful posts

[Muhammad Noman]

Dear Sandeep,

Please find the attached snapshot

[Scott Fella · Accepted solution]

Like Sandeep mentioned, your country code is the issue. If you look at the configured country code on the AP sticker or on the output you attached the -A is for Americas. Your controller has another country code defined BH.  You need to add Americas to your controller if you want that AP to join.

https://www.google.com/amp/s/mrncciew.com/2013/04/07/configuring-country-codes-on-wlc/amp/?client=safari

-Scott 

*** Please rate helpful posts *** 

[Muhammad Noman]

Dear Scott,

                   When i change the country on WLC from -BH to -A then already configured AP which are working with WLC will they also effect or not?

Regards,

Muhammad Noman

[Sandeep Choudhary]

if these old AP have diff. regulatory domain then -A- then of-course it will affect.

If you are not using Mesh APs then you can have "two country- Bahrin and USA" configured on  WLC so that both type of AP will work but only with common channels and power.

Reagrds

Dont forget to rate helpful posts