09-02-2017 02:38 PM - edited 07-05-2021 07:36 AM
Hello Friends
I want extend my local network to remote site. Using AIR-ANT2410Y-R anntennas. I have two AIR-CAP2602I-EK910 model access point and two AIR-ANT2410Y-R model antennas. Local network access switch is C3850. I had configured site to site dynamic VPN but requirements need support broadcast which is not avaialble or not support by VPN.
Please advise how to configure both access points and how to set it? Even I dont know how to access the Access Point.
09-02-2017 05:52 PM
Does your AP has conector for External antennas?
Shouldn't you use 2602e instead?
Apart from this detail, they will work in standalone mode or in WLC?
09-03-2017 06:05 AM - edited 09-03-2017 08:40 AM
Hello
Yes the AP has connector for antennas.
One access point should be transmit another should be receiver Am I right?
Please advise what are the configuration need for Access Point?
Regards,
09-05-2017 02:46 PM
I believe what you need is a Bridge.
Here's the configuration guide:
This is an old document but it may be useful
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: