Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
297
Views
0
Helpful
0
Replies

Flexconnect AP not rejoin to WLC after temporary link failure

rezende.c
Level 1
Level 1

‎11-17-2016 04:15 AM - edited ‎07-05-2021 06:07 AM

Hi all,

    I have a wlc 2504 (8.0.140) in my HQ and 1532 access points in my branch offices working in flexconnect+bridge (mesh) mode.

    When happen a lost of comunication between branch office and HQ the access points not rejoin to WLC when the communication is reestablished and I need to reboot the access points to it back work again.

    Someone know what is the procedure that the access point do to try reach the WLC again? Is there some configuration to tunnning this?

Regards,

Claudio Rezende

   

3 people had this problem
Labels:
0 Helpful
0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card