01-09-2013 07:50 AM - edited 07-03-2021 11:19 PM
Hello
Trying to configure Flexconnect configuration via script but it is not working, anyone got the same problem?
(Cisco Controller) >config ap mode flexconnect AP1
Changing the AP's mode will cause the AP to reboot.
Are you sure you want to continue? (y/n) y
After AP rejoins...
(Cisco Controller) >config ap flexconnect vlan enable AP1
Request failed: flexconnect in the enabled state.
Then cannot apply any other flexconnect command since I cannot enable vlan support
Solved! Go to Solution.
01-09-2013 07:56 AM
You need to admin down the ap before you am run that command.
Sent from Cisco Technical Support iPhone App
01-09-2013 07:56 AM
You need to admin down the ap before you am run that command.
Sent from Cisco Technical Support iPhone App
01-09-2013 10:05 AM
Did you get the command to take? I do this all the time when with no issues.
Sent from Cisco Technical Support iPhone App
01-09-2013 10:22 AM
Thank You,
Command:
config ap disable ap_name
01-09-2013 10:26 AM
Yup that's it... Don't forget to enable the ap:)
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: