FlexConnect support for AP 1600 an 2600?

[Alejandro.Angon]

Hi,

Does any body knows if the access point 1600 and 2600 support flexconnect mode?

thanks

[Stephen Rodriguez]

Yes, both AP are supported for FlexConnect.

just keep in mind you have to be running 7.4 for the 1600 to be supported

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

[Alejandro.Angon]

Hi Stephen,

I have some doubs about the 1600 model, do you kwon any reference about this model and the flexconnect support feature?

Thanks a lot for your help.

[Stephen Rodriguez · Accepted solution]

Cisco WLC Configuration Guide 7.4

http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/consolidated/b_cg74_CONSOLIDATED.pdf

Page 894 "Restrictions for FlexConnect"

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

[Alejandro.Angon]

I have seen yet the reference, thanks a lot for you help Stephen

[Abhishek Abhishek]

Hello Alejandro,

As per your query i can suggest you the following solution-

Yes, the access-point 1600 and 2600 will support flex-connect.

You can refer the link to know how to configure flex-connect on these AP's

http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/flexconnect/config_flexconnect_chapter_01.html

Hope this will help you.