Dear Sir,
My symbol scanner cannot get connected to this access point. The AP has the following status which I managed to captured and did a comparison with another access point.
Failed association to AP,
Under AP radio:internal advanced,
Requested Status --> up
Current status-->up
Packet forwarding -->enabled
Forwarding state--> blocking
Other AP which has clients associated to it,
Under AP radio:internal advanced,
Requested Status --> up
Current status-->up
Packet forwarding -->enabled
Forwarding state --> forwarding
I suspect the radio hardware is faulty as the above AP its forwarding state is in blocking mode. How can I change that into forwarding, any comments?
After restarting the AP, the forwarding state is forwarding.
Thank you.
Delon