cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
246
Views
0
Helpful
1
Replies

Guest Anchor Controller Timeout for clients that haven't authenticated/picked up IP

latintrpt
Level 1
Level 1

Hello,

 

I have a quick question and was wondering if this was customizable.

 

I have a typical guest anchor controller solution and was wondering if clients that haven't authenticated/picked up an IP, if there was a way to adjust the timeout to where they are just seen on the controller.  These clients although not authenticated or picking up an IP are just taking up resources on the guest anchor controllers.

 

Thank You

 

1 Reply 1

Sandeep Choudhary
VIP Alumni
VIP Alumni

Check the timeout setting on WLC for guest users.

 

http://rscciew.wordpress.com/2014/05/07/timeout-setting-on-wireless-lan-controller/

 

Regards

Dont forget to rate helpful posts

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: