cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
296
Views
0
Helpful
5
Replies

How can I restart the host or standby machine in 9800 SSO mode

id404
Beginner
Beginner

Two 9800 sso mode deployments, how to reboot one of the devices via command line or webui?

1 Accepted Solution

Accepted Solutions

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

here is the command :

Force Switchover

If you want to force a switchover between boxes you can either manually reboot the active 9800 WLC or run this command:

# redundancy force-switchover

 

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/213915-configure-catalyst-9800-wireless-control.html

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

5 Replies 5

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

here is the command :

Force Switchover

If you want to force a switchover between boxes you can either manually reboot the active 9800 WLC or run this command:

# redundancy force-switchover

 

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/213915-configure-catalyst-9800-wireless-control.html

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Flavio Miranda
Advisor
Advisor

Hi

 9800 is just like a switch and run IOS-XE. If you want to restart or reload, you can use the commamd "reload" on cli. Make sure you save your config first. 

 When in SSO you can  also access the standby using CLI, but the prompt will be slightly different. 

How can i access the standby using CLI ?

 Just like you access the primary. You just need to use the correct IP address

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

bare in mind - reload from Active will reload both the devices.

 

Once the they are in HA, standby have limited access other than just console access (no commands can be issued)

 

Do you configured any out of Manangement port ?

 

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: