How do I check if an AP in Flexconnect mode is localswitching??

[JustTakeTheFirstStep]

---

How do I check if an AP in Flexconnect mode is localswitching??

AP has been disconnected from WLC.

However, since it operates as flexconnect, AP broadcast the SSID.

Is there a command to check the flexconnect status in AP??

[Rasika Nayanajith · Accepted solution]

Following AP CLI command output will tell it

LAP#show capwap reap status
VLAN - root hwidb:GigabitEthernet0 global BVI:NULL

VlanID BrgGrp Type Routed Active
---------------------------------------------
4114 2 1 yes 1/1
4115 3 2 yes 1/1
4116 4 2 yes 1/1

AP Mode: REAP, Connected

HTH

Rasika

*** Pls rate all useful responses ***

[JustTakeTheFirstStep]

AP_2#show capwap reap status
VLAN - root hwidb:GigabitEthernet0 global BVI:NULL

VlanID BrgGrp Type Routed Active
---------------------------------------------
1 1 1 no 1/1
4114 2 1 yes 1/1
4115 3 2 yes 1/1

AP Mode: REAP, Standalone

In Flexconnect mode, when operating in Local Switching without joining WLC, it seems to be displayed as Standalone.

Am I right?

[JPavonM · Accepted solution]

You can use either Rasika's command to check IOS-AP flexconnect config.

But if you're using COS-AP you can use these ones):

show capwap client detailrcb     ==> shows deeper detail of every SSID been broadcasted
show flexconnect wlan vlan       ==> quick command to show wlanid-2-vlan map for every locally forwarded SSID

-Jesus
** Please Rate Helpful Responses **