cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5019
Views
15
Helpful
10
Replies

How to change dual 5GHz mode to 2.4 & 5 GHz mode for AP3800 ?

HI everyone ,

 

I know the AP3800 support dual 5GHz mode,but we want to use 2.4G & 5G mode.I don't know how to check and change it .Could you please tell me how to change dual 5GHz mode to 2.4 & 5GHz mode?

 

Thanks a lot !

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !
10 Replies 10

Leo Laohoo
Hall of Fame
Hall of Fame
Disable Flexible Radio Assignment (FRA).

HI Leo

Thanks for your response.
Yes, i think so,but where i can disable the FRA ? I didn't find it in GUI.
Could you tell me how to disable it or is there any documents for this issue ?

Thanks & BR
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !


@Rps-Cheers wrote:
Yes, i think so,but where i can disable the FRA ? I didn't find it in GUI.

Wireless > Advanced > RF Management > Flexible Radio Assignment

It is as below:
Wireless > Advanced > RF Managment > Flexible Radio Assignment ,the choose the "disable"

dual 5GHz will be disabled after disable FRA ? Is there any can check i have use the 2.4G&5GHz,not the dual 5GHz?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

 
-hope this helps-

aogston
Level 1
Level 1

Hi.  You can do this manually on the WLC itself. 

Try

config slot 0 disable "AP-Name-Here"  
config 802.11-abgn role "AP-Name-Here" manual client-serving  
config 802.11-abgn band ap "AP-Name-Here" 2.4GHz  
config slot 0 enable "AP-Name-Here" 

 

Regards,

Andy.

Where i can find this in GUI ?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

I do believe that once you follow Leo's guidance: Wireless > Advanced > RF Management > Flexible Radio Assignment

and select Disable, Since this is a Global command, the AP radios that are in the 5g mode will reset back to 2g.

In the auto mode the wlc only moves the radio from 2g to 5g if there is plenty of 2g coverage

also Wireless/Access Points/Radios/Dual-band Radios

will present you your list of 2800/3800 dual band modules..

mouse over to the blue down arrow and select ..  configure.

Radio role Assignment

typically Auto...  make it Manual/Client serving and band 2.4G.

 

 

HI David,

Thanks for your reply.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !
Review Cisco Networking for a $25 gift card