cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1082
Views
20
Helpful
5
Replies

How to Change Radio Role to Client Serving for a C9130AXI-B WAP

CWoods
Level 1
Level 1

I have a C9130AXI-B / 802.11bg:-A 802.11a:-B not broadcasting 2.4GHz radio signal. I checked my other C9130AXI-B WAPs configuration against the config of the device not broadcasting. Its Radio Role is set to Monitor and the others are set to Client-Serving. How can I change the radio role from monitor to client serving for a Cisco C9130AXI-B wireless access point?

5 Replies 5

Hi

 You can use this

 

"ap name apname dot11 |24ghz |5ghz |slot <slot ID> radiorole |auto |manual |monitor |client-serving

Thank you for the info. Im new to the IT field. Learning on the job. I cant seem to get the command "config t" to work. My config options are config 

ap    AP configuration
boot    Set boot parameters
cts    Configure cts debug parameters
mesh    Configure mesh options
security    security information

 

Which option do I choose? Neither seem to work. I really appreciate any assistance you can offer.

ap ? (what options you see ) - may be i was thinking cat 9100 may have different format (need to check command syntax)

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

auxiliary-client      Configure auxiliary-client interface VLAN

        vlan                     Configure Vlan for interface

client-trace           Configure Client Trace

        address                Configure Clients to trace
        all-clients              Trace ALL Clients
        clear                     Clear Client Trace event log
        counter                 Configure Trace counters
        filter                      Set Filters for Client Trace
        output                   Configure Trace Output
        start                      Start Client Trace
        stop                      Stop Client Trace

cloud                    Configure cloud servers

       address                   3cloud server address

tls                         Configure TLS tunnel

       address                   tls gateway address
       auth-method            type of authentication

balaji.bandi
Hall of Fame
Hall of Fame

Before changing - Make sure you are aware of the setup, sometimes as part of the design some AP setup as monitors the wireless in the environment. If that is not the case you can change as suggested.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Review Cisco Networking for a $25 gift card