how to configure QOS for sip phones and 3560 switches.

[Seroj Hacopian]

Hi,

am looking for documentation on how to configuring QOS for sip phones and Qos on 3560 switches for the sip phones

thanks

[Jonathan Schulenberg]

Here you go:

Enterprise QoS Solution Reference Network Design Guide

Campus QoS Design

Catalyst 2970/3560/3750-QoS Considerations and Design

http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/QoSDesign.html#wp999395

[Seroj Hacopian]

Thanks for the link,

I have 100 lwap access points connected to the 3560 switches and new sip phones are going to be used on the wireless network, my question is do I need to just configure the switches that AP's are connected to with QOS or there are additional things I need to do. to complet the qos aspect of it.

Thanks

[George Stefanick]

Here is the LWAPP QoS config guide. This should answer your question.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807e9717.shtml

[Seroj Hacopian]

Thank you, very good link for what I was looking for.

[Jonathan Schulenberg]

This is addressed within the Voice over WLAN Design Guide. I would recommend reading this entire chapter so you fully understand the "art" that is wireless QoS.

Voice over Wireless LAN 4.1 Design Guide

WLAN Quality of Service

IEEE 802.11e, IEEE 802.1P, and DSCP Mapping

http://www.cisco.com/en/US/docs/solutions/Enterprise/Mobility/vowlan/41dg/vowlan_ch2.html#wp1046206

[Seroj Hacopian]

Thank you