06-09-2014 05:34 AM - edited 07-05-2021 12:58 AM
Hello All, I have a production site to move from IOS APs to LWAPP under a local WLC and I need to prepare the following steps
1- save all the configs of the IOS APs : ok
2- convert the configs of those APs into 'something' to be imported from the WLC: can this be done or will I need to put all by hand into the WLC?
thx
06-09-2014 07:16 AM
I had the same challenge when I migrated form IOS to LWAPP.
What I did was duplicated my IOS config on to the controller. Once tested that I can connect to that with out changing configuration on the client side I changed the IOS AP's to LWAPP.
Coming back to your question about importing - I didn't see it. I just added it manually on the controller.
P.S make sure the AP's you are running is compatible with the code required. Also make sure country code is not an issue for you. It was for me since I am running bridges. So I left one AP on IOS.
06-09-2014 11:02 AM
You will need to convert the stand alone AP's to LWAPP's as well.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: