08-20-2015 02:35 PM - edited 07-05-2021 03:48 AM
I have a problem ,i dont know if possible to make password recovery a cisco AIR-SAP2602E-A-K9. can you help me please.
08-20-2015 03:01 PM
Check the following post for Password recovery.
https://supportforums.cisco.com/document/31571/cisco-aironet-access-points-ios-recovery
NotE:- Mostly we use ROMMON for recovery of AP as mentioned. Default user/pass is "cisco".
08-21-2015 08:17 AM
thanks my friend, the problem is that APAIR-SAP2602E-A-K9 cisco is working y my job but i dont know the username and password for this I NEED to know if possible to make password recovery.
08-21-2015 09:48 AM
Your welcome :).
11-30-2015 06:55 AM
thanks my friend, the problem is that APAIR-SAP2602E-A-K9 cisco is working y my job but i dont know the username and password for this I NEED to know if possible to make password recovery without lost the configuration saved?
11-30-2015 11:08 PM
Hello , do you have console access to AP , if you have physical access to AP then there is a reset button on the AP. Hold it for 30seconds, and you will be able to login with default : Cisco/Cisco,
08-24-2015 10:51 AM
http://www.cisco.com/c/en/us/support/docs/wireless/aironet-1200-series/9215-pwrec-2.html
12-01-2015 12:51 AM
The lightweight access point MODE button is configured from your Cisco Wireless LAN Controller. Use these controller CLI commands to view and configure the MODE button:
1) config ap rst-button enable <access-point-name>/all
2) config ap rst-button disable <access-point-name>/all
3) show ap config general <access-point-name>
(Where access-point-name is the name that identifies the access point on the
ocntroller.)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: