06-29-2020 10:45 PM - edited 07-05-2021 12:14 PM
What is the default IEEE 802.1x AP authentication configuration on a Cisco Catalyst 9800 Series Wireless Controller ?
07-07-2020 04:11 AM
01-07-2021 03:49 AM - edited 01-07-2021 03:50 AM
I think I need to wake up this thread.
There is this guide:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/802-1x-support.html#id_79044
But it only shows how to set up PEAP as authentication method.
But I want to use EAP-TLS, and that is only partially explained.
And what I don't understand is, where to upload the necessary certificates, both to the AP and to the WLC
Anyone?
Thanks.
01-07-2021 07:23 PM
What are you trying to achieve here? Is it AP .1x authentication with the wired port or just .1x authentication with the WLC?
Either way you need to upload the certificates to the WLC which will act as a certificate enrollment proxy for the APs using SCEP.
Instructions are in this link to setup a new trustpoint on the WLC for this:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide