implementation queries for cisco wireless AP with controller

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-20-2016 06:27 AM - edited 07-05-2021 04:48 AM
hello and greetings to all readers,
I am given a project to implemet cisco wireless AP's with WLC
platforms are Catalyst 2960-X,2504 WLC and Aironet AP's
but the issue is I am not much familiar with wireless technologies can someone pleas guide me that how should i be doing this project.
Regards,
Zaheer Jahangir
- Labels:
-
Aironet Access Points
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-20-2016 08:51 AM
Hi,
Here is the WLC deployment guide :
http://www.cisco.com/c/en/us/support/docs/wireless/2500-series-wireless-controllers/113034-2500-deploy-guide-00.html
Basic config on switch for WLC and AP:
http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/69719-wlc-lwap-config.html
Regards
Dont forget to rate helpful posts
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-20-2016 10:43 PM
Thanks Sandeep for this helpful content, it will help me for sure,
and preranda i am having total of 4 sites with each site including a total of 15 AP's.....but the issue is I am not comfortable with Wireless technologies as i Have never worked on them before
but thanks for the support now i am sure i can get some fruitful result.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-20-2016 03:32 PM
Hi Zaheer,
assuming you would have at least a dozen of APs..I would start with a small site interview and at least with a basic site survey rather than chucking the AP's here and there.
As for the configuration,deployment guide refereed by Sandeep would be an excellent start for you to get the things going in the lab
-Prabath
