cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
392
Views
0
Helpful
1
Replies

intel centrino and access point 1100

erodrig
Level 1
Level 1

Hi i´m trying to install laptops with intel centrino processor and cisco aironet 1100, but i have no conectivity to the network, i just see associated the laptop in the access point but i can´t reach the network, i have cisco wireless lan adapter too and it works ok, just the centrino is not working, i´m using static wep and mac-authentication

but i just see this in the access point:

sh dot11 associations all-client

Address : 0004.2356.8d25 Name :

IP Address : 0.0.0.0 Interface : Dot11Radio 0

Device : - Software Version :

State : MAC-Assoc Parent : self

SSID : kerry VLAN : 0

Hops to Infra : 1 Association Id : 143

Clients Associated: 0 Repeaters associated: 0

Key Mgmt type : NONE Encryption : WEP

Current Rate : 11.0 Capability : ShortHdr

Supported Rates : 1.0 2.0 5.5 11.0

Signal Strength : -70 dBm Connected for : 319 seconds

Signal Quality : N/A Activity Timeout : 64 seconds

Power-save : On Last Activity : 65532 seconds ago

Packets Input : 132 Packets Output : 2

Bytes Input : 12992 Bytes Output : 118

Duplicates Rcvd : 0 Data Retries : 0

Decrypt Failed : 58 RTS Retries : 0

MIC Failed : 0

MIC Missing : 0

Address : 000e.84b4.58f4 Name : IRMISLAR

IP Address : 192.168.5.243 Interface : Dot11Radio 0

Device : 350-client Software Version : 5.2

State : MAC-Assoc Parent : self

SSID : kerry VLAN : 0

Hops to Infra : 1 Association Id : 154

Clients Associated: 0 Repeaters associated: 0

Key Mgmt type : NONE Encryption : WEP MIC Key-Hashing

Current Rate : 11.0 Capability : ShortHdr

Supported Rates : 1.0 2.0 5.5 11.0

Signal Strength : -62 dBm Connected for : 826 seconds

Signal Quality : N/A Activity

any ideas?

thanks

1 Reply 1

kmarrero
Level 4
Level 4

The Centrino should work with the 1100. Try defaulting the 1100 back to factory defaults so that there is no encryption and configure the Centrino without any WEP. There is probably a configuration glitch with either the WEP or the MAC filter. With no encryption at all the two should communicate and then you can reconfigure the WEP and MAC filtering once everything works.

Review Cisco Networking products for a $25 gift card