IOS Version not showing ap3g3-k9w8 form in AIR-AP3802E-D-K9

[sandeep.thawait]

Hi,

I have AIR-AP3802E-D-K9 i am using "Lightweight Access Point" image and connected with my Wireless controller 2500 series).

When i enter command (within AP) "Sh Flash" or " sh version" in  telnet or ssh it not showing IOS version in the form of  i.e. "ap3g3-k9w8-tar.153-3.JPJ3.tar"

Please tell the command to show my current IOS version in the form of i.e. "ap3g3-k9w8-tar.153-3.JPJ3.tar"

[JPavonM · Accepted solution]

If the AP is lightweigth (CAPWAP) enable, you can see the version of the AireOS code the controller is running with the next command:

(ap)# #show capwap client config

configMagicMark 0xF1E2D3C4
chkSumV2 32067
chkSumV1 29146
swVer 8.5.160.5
(...)

But the good place to look into this version is inside the controller:

(WLC) >show sysinfo

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.5.160.5
RTOS Version..................................... 8.5.160.5
Bootloader Version............................... 7.6.100.0
Emergency Image Version.......................... 7.6.100.0

Yo cannot see the IOS version in that format unless you check your current AireOS software with proper IOS version of the AP here https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html

HTH
-Jesus
*** Please Rate Helpful Responses ***

[sandeep.thawait]

@JPavonM,

Thankyou so much for prompt reply.
My problem is resolved

[Leo Laohoo]

sh boot