03-08-2013 02:27 PM - edited 07-03-2021 11:42 PM
I have a 3602e access point which I need to configure. It has been loaded with an autonomous image (for survey work) and my only access currently is via a browser. Is it possible to http into this access point if its only been imaged and not configured.
I appreciate any help
Thanks
Solved! Go to Solution.
03-08-2013 04:20 PM
03-08-2013 02:41 PM
I believe the autonomous image has limited GUI on the 3600. We have always used the the CLI to configure the 3600 IOS
Sent from Cisco Technical Support iPhone App
03-08-2013 02:48 PM
Thanks but do you know off hand what the default ip address is?
Chris
03-08-2013 03:42 PM
Its dhcp.... there is no default ip address. You would have to console into the ap and set an address on the bvi interface.
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
03-08-2013 04:16 PM
Scott,
Thanks. I polled my DHCP server got the address, logged in and made my changes.
Thanks for the assist
Chris
03-08-2013 04:20 PM
Nice response, Scott.
+5
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: