07-09-2019 01:51 PM - edited 07-05-2021 10:41 AM
Does the Cisco WLC have sufficient logging to keep track of clients that do fast roaming (e.g. 802.11r, 802.11k, 802.11v, 802.11w) between access points on the same WLC? I want to see that clients are NOT simply repeating the entire re-auth process when they switch between different APs that are broadcasting the same SSID.
07-09-2019 03:34 PM
As far as i know no for logging.
You could do some debugs to view the roam process, or over the air packet captures to verify that it is happening as you want
07-10-2019 02:03 AM
@Haydn Andrews wrote:As far as i know no for logging.
You could do some debugs to view the roam process, or over the air packet captures to verify that it is happening as you want
Thanks. What kind of debug commands would you recommend? Would I run the debug command from the WLC, or do I need to SSH directly into the access point?
07-10-2019 02:18 AM
Check this posts:
How to debug client roaming - the 'deep dive'
Regards
Dont forget to rate helpful posts
07-12-2019 03:55 PM
As a starter you could just pick a particular client and use:
debug client <MAC_ADDRESS>
...at the WLC CLI.
You will see the authentication/roam process for that client only.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide