ISP model for Bridges

[jkemery]

Does anyone have some input on the best way to setup a provider senario. I want to put up a bridge in a rural location on a cellular tower and provide service to 3 different businesses. Without putting up 3 seperate WLANs, what way do you suggest to seperate the traffic? Filters??? VLANS???

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

[ertrqueen]

There's a new feature in the 11.08T version of code for the 350 Access Points & Bridges called PSPF - Publicly Secure Packet Forwarding - that claims to limit traffic between clients on a WLAN. Check out this link:

http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo_350/accsspts/ap350rn/rn1108t.htm#xtocid175845

I haven't tried it yet, but it appears to address your question. Good luck........Janet