cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5227
Views
5
Helpful
27
Replies
rguzman.plannet
Beginner

LAP1242 cannot join the WLC2500

Hi,

I have some LAP1242 which by mistake were bought for Mesh. I am trying to convert them to LWAPP so what I did first was to convert them to Stand Alone then to LWAPP but I cannot get the AP to join the WLC and sends several error logs.

I attached some logs taken from AP and WLC so that you can figure out what's going on.

I wonder if I have to remove anything from flash either on SA or LWAPP mode (I know that in some cases you have to delete privete-config in order to avoid the AP taken previous configurations). By the way I think I had never seen this c1240-k9w8-mx.124-25e.JA2 on an AP IOS before, I wonder if it has to do with the mesh thing.

Thank you!

27 REPLIES 27

Well I have 7.4 on a 2504 and 5508 now. It's my he lab so I have done testing since the 4.x with a 2106

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***