If you let me know what you want to achieve with the AP, I could try to provide you to steps to configure the AP as needed.
As basic information remember that the access points are layer 2 devices . To be able to configure the unit you need that the unit gets an IP address from the DHCP server on the network and you access the AP via the GUI or CLI using the IP address the DHCP server gave it or if not you can also configure an static IP address on the unit using the console port and assign the required IP address to the BVI1 interface.
Table of Contents
Table of ContentsOverviewConnecting a Catalyst 9800 WLC to Cisco DNA Center ManuallyConnecting an AireOS WLC to Cisco DNA Center ManuallyCisco DNA Center Assurance Deployment Guide References
The purpose of this document...
Securing devices without 802.1X
PSK (Pre-Shared-Key) WLAN is widely used for consumer & enterprise IoT onboarding as most of IoT device doesn’t support 802.1X. While PSK WLAN provides an easy way to onboard IoT, it also introduces challenges as...
Due to the certificate expiration, any new Control and Provisioning of Wireless Access Points (CAPWAP) or Light Weight Access Point Protocol (LWAPP) connection will fail to establish. The main feature that is affected will be the Acce...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...