04-11-2013 09:48 AM - edited 07-03-2021 11:54 PM
Hi all,
I have a wireless network running with Controller WISM2 and I also have a NCS.
I want to know if there is any way to look of individual log of CAPWAP and LAPWAP Access Points. It is better if I can see it through NCS.
I know we can see it through console but it is not that I am looking for.
I appreciate your help.
Regards.
Solved! Go to Solution.
04-11-2013 02:06 PM
Hi,
You can not probably see messages on NCS. But you can probably assign syslog server ip address to the APs via DHCP.
I also remember there was a command that you can apply from the controller where that command allows you to apply commands on the AP and show you the results.
If I remember correctly it was something like "show ap command ...... etc"
Hope this helps
Amjad
Sent from Cisco Technical Support iPad App
04-11-2013 02:06 PM
Hi,
You can not probably see messages on NCS. But you can probably assign syslog server ip address to the APs via DHCP.
I also remember there was a command that you can apply from the controller where that command allows you to apply commands on the AP and show you the results.
If I remember correctly it was something like "show ap command ...... etc"
Hope this helps
Amjad
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide