12-18-2007 06:02 AM - edited 07-03-2021 03:07 PM
Hello...I am having issues with clients who are connecting to LWAPP APs. They are not able to obtain an IP address via DHCP. If I give them a static address on the VLAN they are trying to connect to, they get on fine. The WLC is handing out the IP addresses to the access points, however, the wireless clients are to be getting them from a Windows server. If I wire a client in the network and put the switchport on the VLAN, I can get an address. I have the IP helper address on the VLAN interfaces where it should be. Is there something I need to config on the controller? Is there something on the Windows DHCP scope?
Thanks for the assistance.
12-18-2007 06:16 PM
12-27-2007 05:35 PM
Make sure you have the DHCP server ip address configured in the interface in which the wireless clients will be on. Next I would verify that the management and ap-managers interface vlan identifier is set to "0" (untagged native vlan) and configure the trunk port in which the WLC connects to configured the native vlan.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide