11-07-2007 01:31 PM - edited 07-03-2021 02:54 PM
Hello all,
I am trying to upgrade a 1242 AP to LWAPP using the upgrade tool. However, it is telling me the controller is unreachable.
I checked the controller and I am able to telnet into it from the 6500 sup engine, but not from outside the chassis. there are not ACL's associated to the ports and from the controller CLI it shows telnet is enabled.
Has anyone ran into anything like this?
Thanks,
Kendall
11-08-2007 01:13 PM
If your AP is not on the same subnet of the management interface of the controller, make sure you have route to reach the controller from the AP.
-ST
11-08-2007 01:16 PM
I tested and can ping from the AP (currently in autonomous mode) to the controller management IP.
~Kendall
11-17-2007 05:45 AM
Can you telnet to the WLC from the platform that you are running the LWAPP upgrade tool from?
Has the Controller been configured to accept Telnet access?
Has the Controller been configured to accept
Self Signed Cert (SSC) APs?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide