cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
649
Views
0
Helpful
3
Replies

Maps are not showing rogue details

Prasan Venky
Level 3
Level 3

Dear All,

After upgrading prime to version 2.2 from 2.1, also MSE from 8.0.100.0 to 8.0.110.0 we are unable to see rogue ap, rogue clients, interferers etc.

Only heat map is getting generated. CAS & WIPS services are showing 'in sync'

 

 

 

1 Accepted Solution

Accepted Solutions

vishweswaran.k
Level 1
Level 1

Ensure Maps under Network design are enabled with CAS services and in sync state... Not only controllers...

If not, select the maps and synchronize with MSE CAS services..

 

View solution in original post

3 Replies 3

vishweswaran.k
Level 1
Level 1

Ensure Maps under Network design are enabled with CAS services and in sync state... Not only controllers...

If not, select the maps and synchronize with MSE CAS services..

 

Thanks! I failed to check that maps are synchronized or not. After selecting all maps and selected MSE & CAS it started working.. 

Abhishek Abhishek
Cisco Employee
Cisco Employee

You need to enable CAS services for the heat map to be generated.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: