cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
408
Views
0
Helpful
6
Replies

Mesh via WAP IW6300

Alibek
Beginner
Beginner

Hi all

We deployed Mesh via WAP IW6300/WLC Catalyst 9800-80

But the download is low. Loading is normal. How to achieve the same rx and tx at both ends

 

DownloadDownloadUploadUpload

6 Replies 6

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - Have a look at : https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/214749-tac-recommended-ios-xe-builds-for-wirele.html 

                            Not directly related topic but always useful : 

  -  Review the 9800-80  configuration with the CLI command : show  tech wireless , have the output analyzed by  https://cway.cisco.com/tools/WirelessAnalyzer/  , please note do not use classical show tech-support (short version) , use the command denoted in green for Wireless Analyzer

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

Hi marce1000,

Thanks for the feedback. I will open an official case for tech support

 

 - That's ok , you can already execute my configuration review (too) , as explained in initial reply -> It will give you lots of insights.

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

Alibek
Beginner
Beginner

Hi all, Me again,

Question. Is this antenna AIR-ANT2547V-N-HZ compatible with the IW6300-H-AC-E-K9 for the deployment of MESH?

 

Alibek
Beginner
Beginner

and in which slot is it recommended (A, B, C, D) to connect the MESH method to the antenna? 

Alibek
Beginner
Beginner

up

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers